Step 1: Pop off plastic cover (use your hands - no special tools required).

Step 2: Mark the exterior glass so you can align the sticker on the inside of the glass (painter tape used in the photo).
Mark where to trim the sticker.

Step 3: Trim sticker

Step 4: Test fit sticker on inside of glass.


Optional step: Make application fluid. Fill windex (or similar) bottle 3/4 full with tap water. add 1 tablespoon of dish soap. shake well.  Spray app. fluid on sticky side of sticker and to the surface you are applying sticker to. 

(application fluid allows you to move the sticker once installed and will help reduce the chance of getting air bubbles.
use caution when squeezing out the application fluid as you can scratch the sticker when pushing to hard.  You can use a hair dryer to heat up the sticker if you want to speed up the process of have the sticker dry to the glass)

Step 5: Peel sticker backing, and apply to the glass. 
(if you used app. fluid, spray onto the sticky side of the sticker and to the glass - then apply.)

Step 6: Make sure the sticker look good (aligned properly) 
(if you used app. fluid: squeegee out app. fluid and let dry completely before next step)

Step 7: Slowly peel off application tape. Pop any air bubble you may have with a razor blade.

Step 8: Reinstall plastic cover.

Step 9: You're done! enjoy. shown without brake applied.

Shown with brake applied.